When a heat pump can't keep the house warm, stops running, or starts acting strangely, the cause usually isn't obvious from the thermostat. We handle heat pump repair in Greensboro, NC, and Advance by testing first, then explaining what we found and what the fix costs. We repair heat pumps year-round, including cooling problems.
Heat pump struggling to keep up? Ask Webb to diagnose the problem and explain your repair options. When you schedule online or call (336) 439-6150, we'll ask what the system is doing and confirm an appointment time.
Common Heat Pump Problems We Assess in Greensboro
A heat pump moves heat instead of making it, pulling heat indoors in winter and pushing it outside in summer. That two-way design means very different faults can produce the same symptom:
| Symptom | What it can point to | When to call |
|---|---|---|
| Not heating enough | A dirty filter, restricted airflow, a refrigerant leak, a failed sensor, or a cold snap below the system's balance point | The house can't hold the thermostat setting |
| Weak airflow | A clogged filter, blocked returns, a dirty indoor coil, or a failing blower motor | Airflow stays weak after a filter change |
| Repeated cycling | Thermostat settings or location, an electrical fault, a refrigerant problem, or equipment sized wrong for the house | The system starts and stops every few minutes |
| Unusual noises | A failing fan motor, worn bearings, a loose part, or a capacitor or contactor problem | Grinding, squealing, or buzzing without the unit starting |
| Persistent outdoor ice | A defrost control or sensor problem, poor airflow across the outdoor coil, or a refrigerant issue | Ice stays thick after a defrost cycle |
| Won't start | A tripped breaker, a failed capacitor or contactor, or a thermostat or control wiring fault | Nothing runs after you check the thermostat settings |
| Won't change modes | A reversing valve or solenoid problem, thermostat configuration, or control wiring | It blows cool air in heat mode or warm air in cool mode |
| Weak or no cooling | A dirty coil, a refrigerant leak, an airflow restriction, or an outdoor fan problem | The house won't cool down on a summer day |
Because these problems can look identical from inside the house, we test before recommending a repair. A buzzing outdoor unit could be a worn capacitor or something larger, and only measurement tells the difference.
We test ductless heat pump systems the same way, so ductless heat pump repair in Advance or Greensboro starts with diagnosis too. For furnaces and boilers, see our heating repair page.
Defrost: Normal Operation or a Repair Concern?
In heating mode, the outdoor coil runs colder than the air around it, so frost builds up, especially on damp mornings near freezing. The system briefly reverses to melt it. You may see steam, hear a whoosh, notice the outdoor fan stop, or feel cooler air for a few minutes.
That cycle is normal and usually ends within about 15 minutes, and Greensboro's damp winters and freezing rain can make it frequent.
Schedule an assessment if you see any of these instead:
- Heavy ice that doesn't clear: Thick ice on the coil or in the base after a defrost cycle can point to a control, sensor, airflow, or refrigerant problem.
- Defrost that keeps repeating: A system that goes back into defrost again and again without clearing the coil isn't completing the cycle.
- A house that stays cold: If indoor temperatures keep dropping through defrost cycles, the system isn't recovering the way it should.
Don't chip ice off the coil or force the system into another mode to clear it. The fins and tubing damage easily, and the ice pattern helps us find the cause.
When Auxiliary Heat Needs Attention
Most central heat pumps have backup heat, usually electric heat strips in the indoor unit, which the thermostat may show as "aux."
Depending on the system's setup, it switches on automatically in a few situations:
- Cold snaps: Below the home's balance point, the heat pump can't keep up with heat loss, so backup heat fills the gap.
- Defrost cycles: Backup heat often runs during defrost so the air from your vents doesn't turn cold.
- Large thermostat increases: Raising the setting several degrees at once, or recovering from a deep overnight setback, can call on backup heat.
Seeing "aux" at those times is expected. Backup heat that runs for long stretches in mild weather, rooms that stay cold with it on, or bills that climb without explanation deserve a look. We weigh those signs against the weather and your system's setup before calling it a problem.
What to Expect From a Heat Pump Repair Visit
Here's how a heat pump system repair in Greensboro, NC, or the surrounding Triad works:
- Scheduling and symptom intake: We ask what the system is doing, when it started, and whether heating, cooling, or both are affected, so the technician arrives ready to test the likely causes.
- Professional diagnostics: The technician starts with what you've noticed, including error codes, noises, or ice, then tests the parts of the system those symptoms point to.
- Findings and repair options: We explain what we found, what's causing the problem, and your options for fixing it, including the trade-offs when more than one approach makes sense.
- Price approval: You see the price before any repair work begins, and nothing moves forward until you approve it.
- Repairs: Many repairs can be finished during the same visit with parts from the truck. When a part has to be ordered or a warranty claim needs approval, we schedule a return visit.
- Operational checks: We run the system and confirm the affected modes work, including heating, defrost, and backup heat where they're part of the problem.
Testing is what lets us price the right repair instead of guessing. Depending on the symptoms, diagnostics cover:
- Controls: Thermostat settings and configuration, control wiring, and the signals between the thermostat, indoor unit, and outdoor unit.
- Airflow: Filter condition, blower operation, the indoor coil, supply and return paths, and clearance around the outdoor unit.
- Electrical components: Incoming voltage, capacitors, contactors, motor amp draw, and connections that can loosen or burn.
- Defrost operation: The defrost control and sensors, and whether the system enters and exits defrost when it should.
- Refrigerant performance: Pressures and temperatures compared with the manufacturer's targets, which show whether there's a leak or a restriction.
- Backup heat: Heat strip operation and the thermostat settings that decide when backup heat runs.
What Can You Safely Check Before Service?
A few quick checks can rule out simple causes. Follow your owner's manual for your specific equipment:
- Thermostat settings: Confirm the mode is right, the setpoint is above room temperature for heat or below it for cooling, and no schedule is overriding it.
- Air filter: A clogged filter restricts airflow in both modes, so replace or clean it with the size and type your system calls for.
- Visible airflow blockages: Make sure furniture or rugs aren't covering vents and returns, and that leaves or snow aren't piled against the outdoor unit.
- Error codes: If the thermostat or unit shows a code or blinking light, write it down to share when you call, without removing any panels.
Leave refrigerant, wiring, and internal parts to a technician. If the system smells like burning, grinds, buzzes loudly, or keeps tripping its breaker, shut it off and call us. Emergency heat is a manual setting that shuts off the heat pump and runs backup heat only, so check with us before relying on it.
Heat Pump Repair Cost, Timing, and Replacement Options
Repair cost depends on what diagnostics find and comes down to a few factors, including parts, labor, and access:
- Diagnostic work: Some problems show up in minutes, while intermittent faults take longer to track down.
- Component cost: A capacitor or contactor costs far less than a coil, a reversing valve, or a major motor.
- Equipment access: Indoor units in tight attics, crawlspaces, or closets take more labor to reach.
- Warranty status: A part still under manufacturer warranty can lower your cost, though labor coverage varies.
- Parts availability: Common parts are often on the truck, while others have to be ordered and can add a return visit.
Cost is only part of the repair-or-replace decision, which also weighs the system's age, condition, and repair history. Many heat pumps last roughly 10 to 15 years, but no single age or dollar amount decides it. If replacement deserves a look, see our heat pump services and our guide to heat pump considerations.
Why Greensboro Homeowners Choose Heat Pump Service From Webb
Triad heat pumps work in both directions, cooling through long, humid summers and heating through winter cold snaps. We’ve been keeping them running since 1978, and today we provide heat pump service in Greensboro, NC, and across the Triad from offices there and in Advance:
- NATE-certified technicians: Our technicians hold NATE certification, earned by passing industry exams on heating and cooling equipment.
- Clear findings and your choice: You see what we found and the price before any work begins, and the decision stays with you.
- Stocked service vehicles: Our 65 fully stocked vehicles carry common heat pump parts, which can help more repairs wrap up in one visit.
- Emergency response: We offer 24/7 emergency response for urgent problems like complete heat loss.
- In-house electrical expertise: When a heat pump problem traces back to wiring, a breaker, or the panel, our electrical team can handle it.
- A+ BBB rating and satisfaction guarantee: We hold an A+ BBB rating and back our work with a 100% satisfaction guarantee.
Not sure whether your problem is urgent? Call, and we'll help you decide.
Schedule Repair and Protect Ongoing Performance
Whether it's ice that won't clear, backup heat that won't quit, or a system that won't start, we find the cause before recommending a fix.
Is your heat pump no longer providing heating and cooling during severe Greensboro weather? Call us today for emergency service at (336) 439-6150. For heat pump service in Advance or Greensboro that isn't urgent, schedule online and we'll confirm availability.
After the repair, heating maintenance can catch small problems before the next cold snap, and a Webb home service agreement keeps those visits on schedule with repair discounts.
Schedule Online(336) 439-6150Frequently Asked Questions
Heat pump air often feels cooler than furnace air, typically 90 to 110 degrees off the coil, so a working system can still feel lukewarm. If the house can't hold the setting, common causes include a dirty filter, restricted airflow, a refrigerant leak, or a defrost or sensor problem.
A light frost that clears during a defrost cycle is normal in winter. Thick ice that stays on the coil, builds up in the base, or returns right after defrost is not, so call us rather than chipping it off.
No. Backup heat is designed to help during cold snaps, defrost cycles, and large thermostat increases, so seeing "aux" is often normal. It's worth an assessment when it runs for long stretches in mild weather or your bills climb without explanation.
Yes. We offer 24/7 emergency response for urgent problems like complete heat loss, and we're staffed for after-hours and weekend calls during heating season. Call (336) 439-6150, and we'll confirm timing when you reach us.
Most heat pump problems can be repaired, especially on a system that has been reliable and maintained. Replacement makes more sense when an older system needs a major repair, keeps failing, or can't keep the house comfortable. We'll explain the trade-offs so you can decide.









